Work has begun on a new white shirt. I really liked this design by Katherine Brenne for Vogue, 9162. I like the tailored hi-lo hem as the higher front gives more leg length for me and the back covers my bum. Something about those curved hi-lo hems just doesn't appeal to me, however. As I often advise. I took a close look at the pattern photo. Look with me here. The mandarin type collar is very deep, something that may be out of proportion to my petiteness. The same goes for the pocket. These are intentionally large details but I think they still are not the right size for someone five feet tall and not too wide. The armscye seam is barely above the elbow. Then there was the issue of width. I know this is supposed to be a wide bodice but I just wasn't feeling sure about it all. . Time to flat pattern measure!
This top is 63 inches wide in the extra small size, sorry, just way to much for me. It was clear this pattern would require some major "petite-ing" to work on my frame.
When I sew I always start with the smaller details. I took one quarter inch off every edge all around the pocket. That meant that the facing wouldn't fit. I had a brain fog moment or maybe just over thought, but something told me not to do the same with the pocket facing. Yikes, would the edges, the curve, not fit if I did? Rather than spend time with this math moment, I cut back the vertical edges the same 1/4 inch and folded out the remaining 1/4 inch across the facing, perpendicular to the grain. It works.
Next was dealing with that deep collar.
Again, I folded out a quarter inch across the center of the collar, perpendicular to the grain. Once that was made permanent by fusing a strip of leftover interfacing to the back, it was time to cut.
In my wild enthusiasm here, I took a pic of me truing the seam for the largest size but you get the idea. The edge was trued. The seam allowance attaching to the neckline was not altered in any way. Now for that amplified bodice!
Nowhere on the pattern is offered finished measurements. Really, Vogue? Is it assumed that this is so stinkin' big that it doesn't matter? Well, it does matter. I am making the extra small. It is for a 29 1/2 inch bust. I haven't seen that measurement since I was prepubescent, way pre pubie. I went ahead and measured the width. There are no pleats in the back. The bodice width at the waistline and hem is 63 (yikes!) inches and that is for the XS!. I do think I can let a bit of that go.
Four inches were taken out of the back bodice, two on each side. Then two inches were taken out of the bodice left and right, two different pattern pieces, so a minus of 8 inches total. This leaves a bodice width of 55 inches. I will live with that as this is a BIG shirt and the bodice should be wide. But when the bodice is wider than I am tall, well that's a problem. Once the width was folded out vertically the shoulder seams needed to be trued as shown in the pic above.
When all is said and done, will this swamp me? Will it look totally out of proportion? Will the ninth planet remain hidden behind the sun? I don't know the answers but we will find out soon enough, at least on the first two questions! Talk to Neil Degrasse about the third question.
When all is said and done, will this swamp me? Will it look totally out of proportion? Will the ninth planet remain hidden behind the sun? I don't know the answers but we will find out soon enough, at least on the first two questions! Talk to Neil Degrasse about the third question.
*******************************
I found this little number in the clearance area at Joanns. Imagine, a bound buttonhole tool! I haven't read the directions yet but am anxious to give it a try. Has anyone ever used one of these?...Bunny
